Gas holdup increases with the increase of impeller rotating speed and aeration rate.
气含率随搅拌转速和通气速率的增大而增大。
At this time is bound to give rise to rotating impeller and the pump shell friction.
这时转动势必会引起叶轮与泵壳得摩擦。
The design of the blast house and the choice of impeller head is the key introduced.
着重介绍了抛丸室的设计，抛丸器的选型和布置。
Design and mapping of impeller blade of centrifugal water pump of high specific speed
高比转速离心泵叶轮的设计与绘型
Principle and Application of Impeller Blasting for Treatment of Deck Floating Slurry.
抛丸技术处理桥面水泥浮浆原理及应用
Study of Unsteady Flow and Fatigue Reliability of the Reactor Coolant Pump's Impeller.
核主泵叶轮非定常流场及疲劳寿命可靠性分析
Kinetic pumps pass kinetic energy to the fluid by means of a rapidly rotating impeller.
动力泵依靠高速旋转的叶轮将动能传给流体。
rampflow impeller of liquid along the axis is tilted in the direction outflow impeller.
斜流式叶轮液体是沿着轴线倾斜的方向流出叶轮。
Large eddy simulation of interior flow field in front guide impeller of axial flow pump.
轴流泵前置导轮内部流场的大涡模拟
A Permanent Implantable Pulsatile Impeller Heart with a Specially Devised Needle Bearing
永久性可植入式搏动流叶轮型人工心脏的探索与研究
The rotation direction of impeller is based on the direction indicated by rotation arrow.
叶轮旋转方向，以转向箭头所示方向为准。
Error is found. impeller is not balance. Tile pump shaft is not concentric with the motor.
泵发生汽蚀。叶轮不平衡。泵与电机不同心。地脚螺栓松动。
Mixing time decreased with the increase of impeller speed at the same volume concentration.
当搅拌桨安装在槽中间位置时所对应的混合时间最小。
Comparison research of the twisted impeller and the straight impeller in the cross flow fan
贯流风机变斜式叶轮和常规直叶轮的对比研究
New Surface Aerating Machine of Composite Impeller and Inverted Umbrella and Its Application
新颖复合叶轮倒伞表曝机及其应用
Influence of Pump Impeller Diameter on the Hydraulic Characteristics of Low Head Pump System
水泵叶轮直径对低扬程泵装置水力性能的影响
Note singlestage centrifugal pump for a single suction inlet of an impeller centrifugal pump.
注齿轮油泵为一个叶轮一个进油口的泵。
Research on Developable Ruling Blade Surface Design Method for Vehicle Turbocharger Impeller.
车用涡轮增压器可展直纹面叶片设计方法研究
A method to machining twisted impeller of Roots blower with NC shaping machine was introduced.
介绍了一种用数控刨床加工罗茨鼓风机扭叶转子的方法。
Partition of calculational section of guide impeller; calculation of emplacement angle of vane.
导轮的计算截面的划分和叶片进出口安放角计算。
Reserch of Design of Radial and Mixed Flow Three Dimensional Impeller with Forward Curved Blades
径、混流式前向三元叶轮成型设计研究
Foreign company begins to adopt integrated compressor impeller in their series of turbo chargers.
国外公司在其系列增压器中开始采用整体式压气机叶轮。
The key to design an auxiliary impeller seal is to determine the opposite pressure coefficient K.
反压系数的确定是设计副叶轮密封的关键。
The material is in the center of the impeller part in view of the impeller center into feed tube.
物料由叶轮上部分料器的中心入料管进入叶轮的中心。
Improving the entry angle of the impeller in a centrifugal pump to adapt for the inflow condition.
改进叶轮进水角。使之适应来流条件，达到进口无撞击。
英文例句大全为您提供impeller英文例句大全,impeller英文造句,关于impeller的英语句子,单词impeller怎么造句,impeller英文例句大全有哪些,哪些英语句子是关于impeller,英语单词impeller的句子,单词impeller如何造句,impeller怎么造句等。