Effect of vapour condensation on hot steam ejector system of supersonic wind tunnel
水蒸汽凝结对超声速风洞蒸汽引射系统的影响

The Optimal Design of Angle Ejector of Injection Mould of The Calculator Lower Cover
计算器下盖注射模斜顶杆机构的优化设计

Design and Numerical Simulation on the Exhaust Ejector System of Vehicle Power Cabin
动力舱排气引射器设计及其内部流场数值模拟

Flow analysis and validation of rocket ejector mode for rocket based combined cycle.
火箭基组合循环发动机引射模态流动分析

The Design and Research Long Throat Water Jet Air Ejector with Gland Steam Condenser
长喉部射水抽气器带轴封冷却器的设计与研究

Application of Reliability Calculation in Ejector Diameter Design of Die Casting Mold
可靠性计算在压铸模顶杆设计上的应用

The direction of movement of this ejector pin is, therefore, controlled by this hole.
因此顶杆的运动方向由这个孔来控制。

The Experience Norms of Design of Ejector Pin of Ejector Pin Ingot Stripper Mechanism
顶杆脱模机构中顶杆的经验设计准则

Ability to maintain and repair core and ejector pins, die springs, and other material.
具备维护和修理模心，顶出针，模具弹簧等其它配件。

Manufacture and application of automatic oil ejector of incline shaft hoist steel rope
斜井提升机钢丝绳自动注油器制作与应用

Performance simulation and analysis of steam ejector under different operating condition
蒸汽喷射压缩器的变工况特性分析

A Second Ejector Mechanism for the Lamp Hood and the Calculation of the Relative Dimensions
灯罩塑件二次顶出机构及尺寸计算

Because you'll release this section of the roof and engage and fire the passenger ejector seat.
因为你会开了车顶和启动和发射乘客弹射座椅。

The Numerical Simulation and Experimental Study of the Marine Gas Turbine Exhaust Ejector System
船用燃气轮机排气引射器数值模拟及实验研究

Experimental and Numerical Study of Ejection Characteristics of Circular Lobe Ejector with Bend Mixers
圆排波瓣弯曲混合管引射实验与数值模拟

a mechanism in a firearm that pulls an empty shell case out of the chamber and passes it to the ejector.
火器中的把空壳退出枪膛并把它传送给排出器的装置。

Optimal design of bow jetting apparatus sand removing ejector dredger for Tongguan section of Yellow River.
黄河潼关河段清淤射流船首部射流装置优化设计

Experimental Research on the Perfonaance of Liquid Gas Ejector at Low Back Pressure and Low Suction Pressure
低背压与低吸气压力下液气引射器性能的实验研究

The location of the ejector pin elements, and the number used, is dependent on the components size and shape.
顶杆零件的位置和数目，取决于塑件的尺寸和形状。

Because of the last point, the positioning of these support pillars is always delayed until after the position of the ejector element has been decided upon.
由于这个原因, 这些支撑柱的位置确定总是在顶料零件之后。